How much DE powder does a pool filter need, and when should I backwash?

Use the amount your filter's maker specifies for that model. It's usually printed on the filter label or in the manual, and it depends on the filter's area. Backwash when the pressure gauge reads about 8–10 psi above its clean reading, then recoat with fresh DE. Too much or too little can damage the filter.

Diatomaceous earth (DE), such as Radiolite from Showa Chemical Industry in Japan, is a fine powder made from fossilized algae shells. In a DE filter it coats fabric grids and traps particles far smaller than sand can catch. It works well, but only when the dose matches the equipment.

The dose belongs to the filter, not the powder

Every DE filter is designed for a set amount of DE, based on its filter area. The maker prints it on the filter’s label or in its manual. Follow that number. Don’t copy what another pool uses, and don’t guess.

If you can’t find it, get the filter’s brand and model and check with the maker or your pool equipment supplier before you dose.

How a DE cycle works

  1. Coat the grids. With the pump running, pour the measured DE, mixed into a slurry with water, slowly into the skimmer. It settles on the grids as a thin, even cake.
  2. Note the clean pressure. Read the gauge right after coating. That’s your baseline.
  3. Filter. As dirt collects, pressure rises.
  4. Backwash when pressure is about 8–10 psi above the baseline, or as your filter’s manual says.
  5. Recoat. Backwashing strips the cake off the grids. Add fresh DE before the filter runs again.

Every so often, open the filter and hose the grids clean. Backwashing alone doesn’t get all the old cake off.

When the filter breaks, check the dosing first

I’ve heard of damaged filters where the brand of DE got the blame, without anyone looking at what really caused it. Usually it’s how the filter was run:

  • Too much DE fills the gap between grids, so pressure shoots up fast and the grids can bend or tear.
  • Too little DE, or running after a backwash without recoating, leaves bare fabric. Fine dirt clogs it and wears it out.
  • Skipped backwashes let pressure climb far past the limit and strain the grids and the pump.
  • DE in the wrong filter. DE is for DE filters. Sand and cartridge filters work differently, so check their manual before adding anything.

Before you blame the powder, check the dose, the pressure log and the backwash routine.

Handle the powder carefully

DE is a fine dust. Wear a dust mask when you open the bag and mix the slurry, and don’t breathe the dust. Follow the SDS for the product you buy, and dispose of spent DE according to local rules.

Need DE for your filter?

Send me your filter’s brand and model, and how often you backwash. I’ll help you work out how much to order.

Chemicals in this answer

Still not sure?Ask Mark