Do you have defoamer for water and wastewater treatment?

A defoamer, or antifoam, knocks down foam in aeration tanks, clarifiers, digesters and cooling towers. Three types do the job: silicone emulsion, polyglycols (PPG and EO-PO copolymers) and mineral oil. The right one depends on where the foam forms, what is causing it, and whether your system allows silicone.

A buyer who runs water and wastewater systems asked me this plainly: “Do you have defoamer?” It’s a fair question, but the better question is which one. Each defoamer chemistry suits a different part of the plant, and the wrong choice can foul equipment or add load to your effluent.

The three main types of defoamer

Silicone emulsion (PDMS). This is the most widely used. It works at very low dosages, in the ppm range, across a wide pH and temperature range. Avoid it where silicone is restricted, such as ahead of RO or UF membranes, or where treated water goes back into a process.

Polyglycols (PPG and EO-PO copolymers). These are non-silicone and water-dispersible. Higher molecular weight polypropylene glycol (around 2000 and up) and EO-PO block copolymers are the usual choice where silicone isn’t allowed. One caution: polyethylene glycol (PEG) is not a defoamer. It’s too water-soluble, and it can even hold foam up.

Mineral oil–based. This is the economical option for aeration basins and sludge handling. Per liter it’s less efficient than silicone, and it adds to the oil-and-grease and COD load of your effluent.

Four things to check before choosing

  1. Where the foam forms. The aeration tank, digester, clarifier, cooling tower and membrane system each suit a different chemistry.
  2. Whether silicone is permitted. Check your system and your discharge limits.
  3. What’s causing the foam. Surfactant or detergent foam responds well to a defoamer. Thick, brown biological foam, often from filamentous bacteria such as Nocardia, is a process problem. A defoamer will only mask it.
  4. What you use now, and at what dosage. That lets me match it or do better.

Need a defoamer?

Send me your application, where the foam occurs, and your monthly volume. I’ll tell you which type fits and send you a quotation.

Still not sure?Ask Mark